NXP Semiconductors KW45B41Z-EVK - GPOs; Board Errata

NXP Semiconductors
KW45B41Z-EVKUM
KW45B41Z-EVK Board User Manual
X
X
X
X
X
X
X
X
J5
X
X
2 1
4 3
6 5
8 7
10 9
12 11
14 13
16 15
18 17
20 19
LPSPI1_PCS1
LPSPI1_SIN
GND
X
LPSPI1_SOUT
LPSPI1_SK
X
X
X
X
X
GND
VBOARD
X
GND
P5V
X
X
J6
15 16
13 14
11 12
9 10
7 8
5 6
3 4
1 2
X
X
INT_N_2
X
X
nRESET_2 — WUU0_P12
RDY_N_2 — INT_COMBO
X
Figure 26. Ranger 4 UWB socket connector pinouts
2.12 GPOs
Table 19 lists the target MCU pin that is used as general-purpose output (GPO) on the KW45B41Z-EVK board.
This pin is used for GPO purpose when not used for its primary purpose.
Target MCU pin Primary function (device) GPO function (device) GPO mode control
PTA20 TPM0_CH1 (RGB LED) RF_GPO_2 (Arduino socket
DL connector J1)
GPO mode is controlled
through configuration resistor
R35
Table 19. Target MCU GPO
2.13 Board errata
No known errata.
KW45B41Z-EVKUM All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
User manual Rev. 2 — 13 February 2023
40 / 50