14
TURN ON/OFF THE CAMERA POWER(Fig.4)
Press the power button once to turn on the camera's
power, the lens will extend forward and stop at wide
position. It is ready for shooting. Press the power
button once again to turn off the camera's power,
the lens will directly retract back to the off position
no matter what position is previously.
AUTO POWER OFF SYSTEM
If the camera is at power on and non-operated for
more than 5 minutes, the system will turn off the
camera power and retract the lens to the "off"
position. Press power button once again to turn on
the camera's power.
LOADING THE FILM(Fig.5)
The camera uses standard 35 mm 135 size film
magazines with DX coding. The film speed (ISO
100~400) is set automatically when the film is
loaded.
1. Push the back cover latch upward toward direction
of the arrow to open the back cover.
Be careful not to touch the lens inside the camera.
Check to see whether the camera is loaded with
a film or not by looking through the film check
window.
2. Place a new roll of film in the film chamber. Draw
out the tip of the film, holding the magazine in
place.
3. Draw out the film tip as far as the FILM TIP mark
inside the camera.
To Next Page
Loading...
Need help?
General