23
SELF-TIMER MODE (Fig.11)
This mode automatically releases shutter after a
delay so that the person taking the picture can be
included in the image.
1. Press the self-timer button, and this mode
selection indicated by an arrow on the status
LCD panel.
2. User can select any photography mode (flash/
subject mode) by toggling the mode selector
button until the desired mode is displayed by any
arrow on the status LCD panel.
3. Press the shutter button.(Only for remote control
mode)
4. After 10 seconds, an image is captured and the
timer will not turn itself off. To exit from this mode,
user needs to press the self-timer button once
again.
The self-timer LED on the front of the camera will
blink in red for 10 seconds. In the first 7 seconds,
the LED blinks at a rate relatively slow and then
blinks rapidly for the last 3 seconds.
If you want to cancel the operation while the self-
timer is in operation, press the power button to
turn off.
AUTO FILM REWIND
1. When the loaded film reaches the end, it is
automatically rewind. The icon on the status
LCD will blink during rewinding process.
2. Rewinding will automatically stop after the film is
completely rewound. The '0' in the film counter
blinks for about 5 seconds, and the LCD panel
will be turned off.
To Next Page
Loading...
Need help?
General