15
4. Close the back cover firmly.
5. When you close the back cover, the film is
automatically advanced to the first frame position.
If the film is not properly loaded, the camera will
run auto loading as well, but "0" instead of "1"
displayed and the icon will blink. In this case,
open the back cover and try to load the film into
the camera once again.
Automatic film loading can be done no matter if
power is on or off.
HOLDING THE CAMERA(Fig.7)
1. Keep your elbows down to hold the camera
steady.
2. Whether for vertical or horizontal photography,
hold the camera with both hands and brace your
elbows lightly against your body.
3. If the flash is used with the camera held vertically,
the flash unit should be at the top of the camera.
If the flash is used with the camera held vertically,
but the flash unit at the down part of the camera,
the picture (especially portrait) will appear
unnaturally.
4. Be careful that fingers, hair and the camera strap
are not in the way of the lens, the auto-focus
windows or the flash.
5. Hold the camera firmly with both hands in a stable
posture and press the shutter button with your
fingertip.
ZOOMING THE LENS(Fig.6)
At power ON:
1. Press the zoom T button. The lens will zoom in
and stop as the button is released. Holding
To Next Page
Loading...
Need help?
General