AP Mode
Press for 10 seconds after the screen unlock, will be flashing slowly to enter Wi-Fi connection
status.
Click "Add device”, and follow the instructions below to finish connection. display on the screen once
the Wi-Fi connection success.
Note: If it doesn't jump automatically, click "Confirm hotspot connection, next".
NOTE: If connect fails, please make sure your network name and password are correct. And your router,
mobile phone and device are as close as possible.
Wi-Fi reconnection (When Wi-Fi password changes or network configuration changes)
Press for 10 seconds, will be flashing slowly for 60 seconds. Then will be off. The original
connection will be removed. Follow steps above for reconnection.
To Next Page
Loading...
