SPECIAL PROCEDURES
What to Do if Water is in the CVT
The CVT drain plug is located on the
rear portion of the CVT cover. It is
accessible from the rear LH fender.
Inspect the CVT drain plug to
validate if water is present.
NEAR LH FOOTREST
1.Spring clamp
2.Drain plug
NOTE: If water entered your CVT
while in a muddy environment, limit
vehicle usage and bring your vehicle
to your nearest authorized dealer for
a proper CVT cleaning procedure.
If water is present, remove CVT
drain plug to expel water.
Reinstall the drain plug and secure it
using the spring clamp.
NOTE: Make sure drain plug is
properly inserted on CVT cover
nipple.
What to Do if Water is in the Air
Filter Housing
Inspect the drain reservoirs in the
back of the front left wheel inner
fender to validate if water is present.
TYPIAL
1.Clean air filter housing drain reservoir
2. Dirty air filter housing drain reservoir
If water is present, press clamps and
remove reservoirs to drain water
from air filter housing.
If one of the following conditions is
met, bring the vehicle to your nearest
authorized ATV dealer to have the
vehicle serviced:
-If more than 50 ml of water is
found in the clean chamber drain
hose.
- If any deposits are present in the
clean chamber drain reservoir.
- If either hose is obstructed.
To Next Page
Loading...
