MAINTENANCE PROCEDURES
This section includes instructions for
basic maintenance procedures.
Turn off the engine and follow these
maintenance procedures when
performing maintenance.
If you do not follow proper
maintenance procedures you can be
injured by hot parts, moving parts,
electricity, chemicals or other
hazards.
Should removal of a locking device
be required (e.q. lock tab self-locking
fastener, etc.), always replace it with
a new one.
Air Filter
Air Filter Maintenance Guideline
As with any ATV, air filter
maintenance is critical to ensure
proper engine performance and life
span.
Air filter maintenance should be
adjusted according to riding
conditions.
Air filter maintenance must be
increased in frequency and oil must
be added to the foam filter element
for the following dusty conditions:
-Riding on dry sand.
-Riding on dry dirt covered surfaces.
-Riding on dry gravel roads or similar
conditions.
Air Filter Removal
Remove seat.
Remove console.
Lift rear portion of console upwards
until the studs are released from the
grommets.
TYPICAL
1.Console
Pull console rearwards.
Remove the air filter cover.
To Next Page
Loading...
Need help?
General
