PR Series Balance EN-11
3. Press Yes, and (put the reference weight) will
display.
4. Place the reference sample on the pan to display the weight.
When the reading is stable, the * appears.
5. Press the Function / Mode button so that the weight of the
reference sample is stored in memory. The display will show
%.
6. Remove the reference sample, and place the test object on
the pan. The ratio of the test object to the reference sample
weight is displayed as a percentage.
7. To view the reference sample weight or the percentage of the
test object weight to the reference sample weight, press the
Function / Mode button.
8. To establish a new reference sample weight, long press the
Function / Mode button and repeat the steps described
above.
Item Settings
Note: If the reference weight of last Percent Weighing operation
needs to be kept, press No when the message (Clear
reference) displays.
To Next Page
Loading...
