To Next Page
R
Ryan NelsonAug 17, 2025
What does Err 9.5 mean on OHAUS Laboratory Equipment?
- DDaniel LaneAug 17, 2025
If your OHAUS Laboratory Equipment is displaying 'Err 9.5', the loadcell may not be working correctly.
What does Err 9.5 mean on OHAUS Laboratory Equipment?
If your OHAUS Laboratory Equipment is displaying 'Err 9.5', the loadcell may not be working correctly.
What does Err 53 mean on OHAUS Laboratory Equipment?
If your OHAUS Laboratory Equipment shows 'Err 53', it means there is an issue with the EEPROM.
Why does my OHAUS Laboratory Equipment show '--NO--' when taring?
The '--NO--' error on your OHAUS Laboratory Equipment indicates that the tare is out of range.
Why does my OHAUS Laboratory Equipment show '--NO--' when zeroing?
The '--NO--' error on your OHAUS Laboratory Equipment indicates that the zero is out of range.
What does 'LoW.rEF' mean on OHAUS Laboratory Equipment?
The 'LoW.rEF' error on your OHAUS Laboratory Equipment means that the reference weight is low, and this only applies in counting mode.
What does Err 8.1 mean on OHAUS Laboratory Equipment?
The 'Err 8.1' error on your OHAUS Laboratory Equipment indicates an over init zero range.
What does Err 8.2 mean on OHAUS Laboratory Equipment?
The 'Err 8.2' error on your OHAUS Laboratory Equipment indicates an under init zero range.
What does IDnr.Err mean on OHAUS Laboratory Equipment?
The 'IDnr.Err' error on your OHAUS Laboratory Equipment indicates an IDNR error.
What does PUSH.LFt mean on OHAUS Laboratory Equipment?
The 'PUSH.LFt' message on your OHAUS Laboratory Equipment indicates that you need to push the LFT button, specifically for PR.
What does 'No CAL' mean on OHAUS Laboratory Equipment?
The 'No CAL' error on your OHAUS Laboratory Equipment indicates a production calibration failure.
Essential safety guidelines before operation.
Introduction to the parts counting application.
Overview of different calibration methods available.
Customizing various balance functionalities.
Restoring settings and securing menus.
Steps to seal the device to prevent tampering.
Table of common issues and their solutions.
General| Capacity | 420 g |
|---|---|
| Readability | 0.001 g |
| Display | LCD |
| Linearity | ±0.002 g |
| Stabilization Time | 2 seconds |
| Calibration | External Calibration |
| Interface | RS232 |
| Repeatability | 0.001 g |
| Operating Temperature Range | 10°C – 40°C |
| Units of Measurement | g, oz |
| Power Supply | AC Adapter or Rechargeable Battery |
