EN-10 SCOUT
TM
SERIES BALANCES - SPX
4.3 Setup Menu
Enter this menu to set balance parameters.
Note: Bold always represents factory default value
Reset [reset]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Filter [FILtEr]
Set the amount of signal filtering.
LOW = less stability, faster stabilization time
MED = normal stability, stabilization time
HI = greater stability, slower stabilization time
AZT [AZt]
Set the automatic zero tracking functionality.
OFF = disabled
0.5d = the display will maintain zero until a change of 0.5 divisions per second has
been exceeded.
1d = the display will maintain zero until a change of 1 divisions per second has been
exceeded.
3d = the display will maintain zero until a change of 3 divisions per second has been
exceeded.
Stable Range [Stable]
Set the amount the reading can vary while the stability symbol remains on.
0.5d = 0.5 balance division
1d = 1 balance division
2d = 2 balance division
5d = 5 balance division
Back Light [LIGHt]
Sets backlight functionality.
OFF = always off
ON = always on
AUTO = turns on when a button is pressed or the displayed weight changes.
Note: When connected with power pack, the backlight is always on.
Auto Tare [A.tArE]
Set the automatic tare functionality.
OFF = Automatic Tare is disabled
ON = the first stable gross weight is tared
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
Reset: no, yes
Filter: Low, Med, High
Auto Zero Tracking: off, 0.5d, 1d, 3d
Stable: 0.5d, 1d, 2d, 5d
Backlight: off, on, auto
Auto Tare: off, on, on-acc
Auto Off: off, 1, 5, 10
End Setup: Exit menu
To Next Page
Loading...
