OHAUS ST300D-B - Safety Precautions; Display and Controls

EN-2 STARTER 300C Portable Conductivity Meter
1.2 Safety Precautions
CAUTION: Read all safety warnings before installing, making connections, or servicing this
equipment. Failure to comply with these warnings could result in personal injury and/or property
damage. Retain all instructions for future reference.
x Use the equipment only in dry locations.
x Dry off any liquid spills immediately. The instrument is not watertight.
x When using chemicals and solvents, comply with the instructions of the chemical producer
and the general lab safety rules.
x Use only approved accessories and peripherals.
x Operate the equipment only under ambient conditions specified in these instructions.
x Do not operate the equipment in hazardous or unstable environments.
x Service should only be performed by authorized personnel.
1.3 Display and controls
Displays
1
Endpoint stability icon
; Auto endpoint icon
2
Measurement icon - ; measurement or calibration is running
3
Calibration icon - ; calibration in progress
4
Setup icon - ; instrument is in the setup mode
5
Battery status icon shows the condition of the batteries - fully charged, half-charged or fully
discharged
6
TDS factor in the setup mode
7
Conductivity / TDS / Cell Constant
8
Standard / Memory number / Error index
9
Temperature during measurement or reference temperature in setup mode
1
2
3
4
5
6
8
9
7
w ww . . co m
information@itm.com1.800.561.8187