8 / English
Load paper
1. Remove the paper tray from the printer. Place it on
a flat surface and remove the lid.
2. If the base plate of the paper tray is raised, push it
down.
3. Squeeze the length guide and slide it to the
desired paper size (1). Squeeze the right width
guide and slide it to the desired paper size (2).
4. Load the paper with the side to be printed facing
up and with all four corners aligned.
5. Replace the lid of the paper tray and push the tray
completely into the printer.
6. Depending on the types and sizes of the loaded
paper, you need to configure settings on the
control panel:
• Change the paper type when non-plain paper
such as recycled paper, heavyweight paper or
transparencies is loaded.
• Configure the paper size when custom size
paper is loaded unless using Express Print,
which is described under “Print Media” in the
User's Guide supplied on the CD furnished with
your printer.
CAUTION!
Do not place paper over the right width guide.
Do not load paper exceeding the maximum fill
line or the maximum capacity allowed.
Align the right width guide with the paper
width correctly. If the right width guide is not
in place, the paper will not be properly fed
and this may cause paper jams.
CAUTION!
The lid of the tray must be firmly closed. If
not, the paper may become misaligned.
To Next Page
Loading...
Need help?
General
