2
Complete these steps to install your printer on a
network:
1 Connect the Ethernet
Interface.
Note: No Ethernet cable is supplied with the printer.
Use an Ethernet cable with two twisted wire
pairs and an RJ45 plug.
□ Turn the printer off.
□ Remove the plug from the Ethernet port (1),
then connect your Ethernet cable to the port.
□ Connect the other end of the cable to the
network port.
□ Turn the printer on and wait for the print
server’s STATUS light (2) to stop blinking.
□ Press the TEST button (3) on the print server.
The Network Information configuration sheets
print. Keep these sheets handy: they contain
information you need to set up the printer on
your network.
2 Set Up the
Network.
3 Install the Driver.
4 Configure the Print
Server.
5 Activate the
Optional
Accessories.
6 Install/View the
Documentation.
1Connect the
Ethernet
®
Interface.
Windows TCP/IP Network Installation
To Next Page
Loading...
Need help?
General
