116 – C330/C530 Troubleshooting
• To remove a sheet just entering the fuser (1), separate
the trailing edge of the sheet from the belt (2), push the
fuser pressure release lever
(3) towards the front and
down to release the fuser’s grip on the sheet, and
withdraw the sheet through the drum cavity area. Then
allow the pressure release lever to rise again.
• To remove a sheet in the fuser:
Note:
If the sheet is well advanced into the fuser (only a
short length is still visible), do not attempt to pull it
back.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
