21 – C330/C530 Loading Paper
• Do not pull the paper tray out during printing (except as
described below for the 2nd tray).
Notes
• If you have two trays and you are printing from
the 1st (upper) tray, you can pull out the 2nd
(lower) tray during printing to reload it. However,
if you are printing from the 2nd (lower) tray, do
not pull out the 1st (upper) tray. This will cause a
paper jam.
• For face down printing, make sure the face up
(rear) stacker (a) is closed (the paper exits from
the top of the printer). Stacking capacity is
approximately 150 sheets, depending on paper
weight.
• For face up printing, make sure the face up (rear)
stacker is open and the paper support
(1) is
extended. Paper is stacked in reverse order and
tray capacity is approximately 100 sheets of 20-
lb. US Bond (75 g/m
2
) paper.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
