44951501TH Rev.2
5-16
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
4. With PRINT EXECUTE displayed on the lower display by the operation in step
2, pressing the OK button executes test printing by using the setting(s) made in
steps 2 and 3.
The test printing is cancelled by pressing the CANCEL button.
When detected in starting or performing the test printing, an alarm shown in the
Detail section of the following list is displayed on the operator panel, stopping
the printing (for error detail, refer to the operator panel display detail in section
5.3.2.14, where the messages displayed are different from those in PU test
printing).
Panel Display Detail
PAPER END
SELECTED TRAY
No paper exists.
SELECTED TRAY IS
NO T INSTALLED
The selected tray is not
installed.
REMOVE PAPER
OUT OF DUPLEX
An internal error of the
duplex unit.
INSTALL CASSETTE TRAY
OPEN
A cassette is slid out.
Print patterns (cannot be used for print quality checking)
0 and 8 to 15: Each print a blank page.
Pattern 1 Pattern 2
Note: Solid black print (pattern 7) is included
in the local printing function. An offset
occurs when it is output at 100% in
each color. To prevent this, the number
of the colors to print concurrently to
produce solid print copies of the No.
7 needs to be limited not more than
two by making print color settings as
instructed in step 3.
Pattern 3 Pattern 4
Pattern 5 Pattern 6
Pattern 7
To Next Page
Loading...
Need help?
General
