44951501TH Rev.2
3-22
Oki Data CONFIDENTIAL
3. INSTALLATION
3.7 Connection methods
<USB connection>
Note! Refer to the user’s manual for operating environment.
Preparing a USB cable
Note! • No printer cable is supplied with the printer. Ask the user to prepare a USB
2.0 printer cable.
• When connection is to be made in “High-Speed” mode with a USB 2.0, use
a Hi-Speed-ready USB 2.0 cable.
• A USB 2.0 cable to be used must be no more than ve meters long. A USB
cable of two meters or less is recommended.
Switching off the printer and the computer
Memo Although a USB cable can be plugged in or unplugged with the computer and
the printer switched on, for secure installation of the USB driver and the printer
driver to be performed subsequently, the printer should be turned off.
Connecting the computer to the printer
(1) Plug the USB cable into the USB interface connector of the printer.
(2) Plug the USB cable into the USB interface connector of the computer.
Note! Be careful not to plug the USB cable into the network interface connector.
Such wrong connection could cause malfunction.
Memo For the setup procedure of the printer driver, see the user’s manual.
Cover
USB interface connector
Cover
Hook
To Next Page
Loading...
Need help?
General
