44951501TH Rev.2
5-22
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
5.3.2.9 Print counter display
The print counter display is used for viewing print counter values.
1. Enter the self-diagnostic mode and, until PRINTER STATUS appears, press
or
( displays the next test option and displays the preceding test option).
Then press the OK button.
2. Press
or , and each count is printed (the ONLINE or CANCEL button is
disabled).
3. Press
to end the option (the state for step 1 is restored).
Upper display Lower display Format Unit Detail
K-
IMPRESSIONS
********IMAGES Decimal Images Each display the number of a
color's pages printed.
Y-
IMPRESSIONS
********IMAGES Decimal Images
M-
IMPRESSIONS
********IMAGES Decimal Images
C-
IMPRESSIONS
********IMAGES Decimal Images
TOTAL SHEET
CNT
********COUNTS Decimal Prints Displays the total number of pages
printed.
5.3.2.10 Factory/Shipping mode setting
The Factory/Shipping mode setting is used for switching from the Factory to Shipping mode.
1. Enter the self-diagnostic mode and, until the following message appears, press
or .
FACTORY MODE SET
2. Press
or , and the following message appears. Press or until an
option to set (refer to the table shown below) appears.
FACTORY MODE
SHIPPING MODE *
3. By pressing the OK button with the option on the display, a setting for the option
can be selected.
4. Hold down the OK button (for three seconds) with the display showing the
setting to set. The setting is stored in the EEPROM. The state for step 2 is
restored.
5. Repeat steps 2 through 4 when necessary.
6. Press
to end the option (the state for step 1 is restored).
Display Settings Function
FACTORY
MODE
FACTORY MODE Establishes the Factory mode (a fuse-cut disabling
mode).
SHIPPING MODE Deselects the Factory mode to enable the fuse-cut
function.
FUSE INTACT
Note: Six
asterisks
(******)
identifies
INTACT or
BLOWN.
BELT UNIT ****** Displays the fuse status of the transfer belt unit.
FUSE UNIT ****** Displays the fuse status of the fuser.
ID UNIT ****** Displays the fuse status of an image drum unit.
To Next Page
Loading...
Need help?
General
