- 43 -
2. Setting Up
Wireless LAN (AP mode) directly connects wireless devices (computers, tablets,
smartphones, etc.) to the machine without using a wireless LAN access point.
• If there is metal, aluminum sash, or a reinforced concrete wall between the machine and wireless devices,
connections may be harder to be established.
• Up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected.
• Automatic connection (push-button)
If your wireless devices supportWPS-PBC (push button), you can connect to the wireless
LAN (AP mode) with the WPS button.
• Manual Setup
If your wireless devices do not support WPS-PBC (push button), you can enter [SSID] and
[Password] of the machine in your wireless devices to connect to the wireless LAN (AP
mode).
Automatic connection (push-button)
If your wireless devices support WPS-PBC (push button), you can connect to the wireless
LAN (AP mode) with the WPS button.
1
Confirm the position of the WPS button on your wireless device by the manual
attached to the device.
2
Turn the machine on.
If the "Do you want to Set-up wireless?" message appears, select [No (Do not show next time)].
3
Press the button to select [Setting] and press the (Enter) button.
4
Press the button to select [Admin Setup] and press the (Enter) button.
5
Enter the administrator password, and then press the (Enter) button.
The factory default administrator password is "999999". If the administrator password is
changed, enter the updated password.
6
Press the button to select [Network Menu] and press the (Enter) button.
7
Press the button to select [Network Setup] and press the (Enter) button.
8
Press the button to select [Wireless(AP Mode) Setting] and press the
(Enter) button.
The "It is not possible to use the Wireless(infrastructure) at the same time." message is
displayed for approximately five seconds.
9
Select [Enable] and then press the (Enter) button.
10
Press the button to select [Automatic Setup (Pushbutton)] and press the
(Enter) button.
11
When [Pushbutton method] is displayed, select [Yes].
12
Start the WPS-PBC (push button) operation on your wireless device to
connect to the machine.
When the following screen appears, the setup of the wireless LAN is completed.
In case of connection failure, follow the steps in "Manual Setup" to try again.
Manual Setup
If your wireless devices do not support WPS-PBC (push button), you can enter [SSID] and
[Password] of the machine in your wireless devices to connect to the wireless LAN.
1
Turn the machine on.
If the "Do you want to Set-up wireless?" message appears, select [No (Do not show next time)].
2
Press the button to select [Setting] and press the (Enter) button.
3
Press the button to select [Admin Setup] and press the (Enter) button.
4
Enter the administrator password, and then press the (Enter) button.
The factory default administrator password is "999999".
5
Press the button to select [Network Menu] and press the (Enter) button.
6
Press the button to select [Network Setup] and press the (Enter) button.
Connecting to the Machine Directly
To Next Page
Loading...
Need help?
General
Weight and Dimensions
