Menu functions > 34
PCL Setup
(cont.)
A4 Print
Width
78 column
80 column
Sets the number of characters for A4 paper.
Auto LF.
This is for 10-CPI characters when Auto CR/LF Mode is set
to OFF.
This menu is enabled only when A4 paper is selected in
the menu that sets the print width of A4 paper in portrait
orientation.
Usually, such A4 paper print width is set slightly narrower
than 8 inches (about 7.93 inches).
This setting cannot print 80 10-cpi characters (only prints
up to 78 10-cpi characters). 80 characters set at A4 Print
Width widen the right and left margins.
A PCL command selects or selects/deselects Auto CR/LF
mode.
White Page
Skip
On/Off Sets whether to eject a page without any data to print
(blank page) upon reception of FF command (OCH) in PCL
Mode. OFF: Ejecting.
CR Function CR/CR+LF Sets action when CR code is received in PCL.
CR: Carriage Return
CR+LF: Carriage Return and Line Feed
LF Function LF/LF+CR Sets action when LF code is received in PCL.
LF: Line Feed
LF+CR: Line Feed and Carriage Return
Print Margin Normal
1/5 inch
1/6 inch
Sets a non-printable area of paper.
The width of the area along the right and left sides of
paper (left and right sides depend on paper orientation).
NORMAL: PCL emulation compatible, approximately 1/
4~1/4.3INCH (depending on paper) is outside the
printable area.
Tru e
Black
On/Off Sets whether to use Composite Black (cmyk mixed) or
Pure Black (K only) for the black (100%) in image data.
OFF: Mode using Composite Black
ON: Mode using Pure Black
(PCL only)
Pen Width
Adjust
On/Off When minimum width is specified in PCL, sometimes a 1-
dot line, looks broken.
With PEN WIDTH Adjust set to ON, when the minimum
width is specified, the line width will be emphasized so as
to look wider than a 1-dot line.
With PEN WIDTH Adjust set to OFF, the line will appear as
before.
Tray ID#
Tray 2 1 ~ 5 ~ 59 Sets the # to specify Tray 2 for the paper feed destination
command (ESC&l#H) in PCL5e emulation.
(Displayed only if Tray 2 is installed).
Tray 3 1 ~ 20 ~ 59 Sets the # to specify Tray 3 for the paper feed destination
command (ESC&l#H) in PCL5e emulation.
(Displayed only if Tray 3 is installed).
MPTray 1 ~ 4 ~ 59 Sets the # to specify the MP tray for the paper feed
destination command (ESC&l#H) in PCL5e emulation.
ITEM SETTINGS EXPLANATION
To Next Page
Loading...
