Menu functions > 42
Panel Setup Near Life Status Enable
Disable
Sets the LCD display control when a near life
warning occurs for the drum, fuser and belt.
With Enable, a near life warning will be
displayed.
With Disable, a near life warning will not be
displayed (not output to the Attention LED/
PJL/MIB/Web as well).
Excludes the temporary recovery status (life
warning) by opening and then closing the
cover after a life warning has occurred.
Near Life LED Enable
Disable
Sets the LED lighting control when a near life
warning occurs for the toner, drum, fuser,
belt and waste toner box.
With Enable, the Attention LED will light
on.*
With Disable, the Attention LED will not light
on.
Excludes the temporary recovery status (life
warning) by opening and then closing the
cover after a life warning has occurred.
* For the drum, fuser, belt and waste toner
box, this setting is applied only when Panel
Setup > Near Life Status is set to Enable.
For the toner, this setting is applied regardless of
the setting of
Panel Setup
>
Near Life Status
.
Idle Display Toner Gauge
Paper Size
Selects the information to be displayed on
the standby screen. With Paper Size,
displays the paper size for each tray. The
default is the Toner Gauge.
Panel Contrast -10
~
0
~
+10
Adjusts the contrast value of the operator
panel LCD.
Time Setup Date Format mm/dd/yyyy
dd/mm/yyyy
yyyy/mm/dd
Set desired date format.
Time Zone -12:00
~
0:00
~
+13:00
Enter the time zone for your country in
relation to GMT.
Set in quarter units within the range.
Use the Menu up/down buttons to
increment/decrement and press the Enter
button to set and proceed to the next digit.
Daylight Saving On
Off
Enable/disable daylight saving setting.
Setting method Auto Setup
Manual Setup
Sets the time setting method.
SNTP Server (Primary) ************ Sets the SNTP server (primary)
Display Conditions:
Admin Setup > Time Setup > Setting
method is set to Auto Setup.
ITEM SETTINGS EXPLANATION
To Next Page
Loading...
Need help?
General
