Installing upgrades > 74
9. Select Yes, and then press the Enter button.
10. The Printer starts searching for wireless LAN access points. During 2 minutes, press
the easy setup button for the wireless LAN access point for a few seconds.
Once Connection successful is displayed, it indicates that the wireless LAN setup
has completed.
If Connection failed is displayed, repeat the procedure from step 4.
If an antenna appears on the upper right corner of the operator panel, it indicates
that the connection is successful.
Connecting by Selecting a Wireless LAN Access Point from the Control Panel
If the wireless LAN access point does not support WPS, you can connect by selecting the
wireless LAN access point you want to use from those the machine has detected. To do this,
an encryption key is required.
1. Confirm and write down the SSID and encryption key by referring to the user
manual of the wireless LAN access point.
2. Confirm that the wireless LAN access point has been activated and is functioning
normally.
3. Turn on the printer.
4. Press up or down on the operator panel to display Wireless(Infrastructure)
Setting, and then press the Enter button.
5. Enter the Admin password, and then press the Enter button.
6. Press up on the operator panel to select Enable, and then press the Enter button.
7. Press up or down on the operator panel to display Wireless Network Selection,
and then press the Enter button.
8. The printer starts searching for wireless LAN access points. Please wait.
9. A list of available wireless LAN access point SSIDs are displayed. Press up or down,
select a wireless LAN access point, and press the Enter button.
10. A screen opens in which the encryption key may be input based on the encryption
procedure for the selected LAN access point.
MEMO
> The SSID is also called the network name, ESSID, or ESS-ID.
> The encryption key is also called the network key, security key, password,
or pre-shared key.
NOTE
If only Manual Setup is displayed or the desired wireless LAN network SSID
is not displayed, follow the procedure in “Connecting by Manual Setup from
Control Panel” to do the settings.
MEMO
The encryption key differs depending on the wireless LAN access point and
security.
To Next Page
Loading...
Need help?
General
