Oki C831n - Secure Printing

- 36 -
1
1. Convenient Print Functions
For Mac OS X PS Printer Driver
 For Mac OS X 10.5 to 10.6
1 Open the le you want to print.
2 From the [File] menu, select [Print].
3 Select [Color] from the panel menu.
4 Select an appropriate value in [Toner
save].
5 Congure other settings if necessary and
then start printing.
Memo
● If the print dialog contains only two menus and does not
contain the options you expect to see on Mac OS X 10.5
or 10.6, click the button on the side of the [Printer]
menu.
 For Mac OS X 10.3.9 to 10.4.11
1 Open the le you want to print.
2 From the [File] menu, select [Print].
3 Select [Printer Features] from the
panel menu.
4 Select [Job Options] in [Feature
Sets].
5 Select an appropriate value in [Toner
Saving].
6 Congure other settings if necessary and
then start printing.
Secure Printing
You can assign a password to a print job so it
can only be printed if the password is input at
the operator panel.
In order to use this function, the printer must be
equipped with the optional SD memory card kit.
Note
● If the spooled data cannot be stored in the SD memory
card because of a memory shortage, a message indicating
that the data is invalid appears.
● This function is not available with the Windows XPS
printer driver and the Mac OS X PS printer driver.
For Windows PCL Printer Driver
1 Open the le you want to print.
2 From the [File] menu, select [Print].
3 Click [Preferences] or [Properties].
4 Select the [Job Options] tab.
5 Select [Secure Print] at [Job Type].
6 Enter a job name in the [Job Name]
box and a password in the [Job
Password] box.
If you select the [Request Job Name for each
print job] check box, a prompt for the job name
appears when you send the print job to the
printer.
7 Click [OK].
8 Congure other settings if necessary and
then start printing.
The print job is sent to the printer, but is not
printed.
9 Press the <Fn> key.
Memo
● When a printer is in the power saving mode, press
the <POWER SAVE> button to restore from the
mode.
10 Enter <0>, <0> and <2> using the
ten-key pad and press the <ENTER>
button.