Loading paper > 34
3. Load paper (letter headed paper face down and top edge towards the front of the
printer), as shown.
4. Adjust the rear stopper (a) and paper guides (b) to the size of paper being used.
5. Close the paper tray gently.
6. Set the correct paper size. Refer to “Configuring the tray settings” on page 36 and
“Registering custom sizes” on page 37.
To prevent paper jams:
> Do not leave space between the paper and the guides and rear stopper.
> Do not overfill the paper tray. Capacity depends on the type of paper stock.
> Do not load damaged paper.
> Do not load paper of different sizes or types at the same time.
> Close the paper tray gently.
NOTE
After closing the tray, the media selection screen will be displayed on the
panel.
To Next Page
Loading...
