5
•
English
Walk-up Operation
General Information
Power Save Mode
Power Save sets how long the
printer waits before going into
standby mode. This saves energy,
but the printer requires time to
warm up when it receives a print
job.
The system comes from the
factory set for a 30-minute delay
before entering the Power Save
Mode.
When the system is in Power
Save mode, the Power Save
button is lit. To disengage the
Power Save mode, press the
Power Save button.
Changing the Power Save
Settings
1. Press the S
ETUP
button on the
control panel.
2. On the
Setup
screen, press
Admin Setup
.
3. Type in your password (the
default password is aaaaaa),
then press
Enter
.
4. Press
Management
.
5. Press
䊳
, then press
Power
Save
.
6. To switch Power Save on of off:
a. Press
Power Save Enable
.
b. Press
OFF
or
ON
.
c. Press
Enter
.
7. To change the time setting:
a. Press
Power Save Time
.
b. Press the desired time (
5,
15, 30, 60 , or 240
minutes)
c. Press
Enter
.
8. Press
Close
.
9. Press the C
OPY
button.
To Next Page
Loading...
