Why does my Oki Copier say 'READY (TONER NOT RECOGNIZED)'?
The 'READY (TONER NOT RECOGNIZED)' message on your Oki Copier indicates that the toner cartridge is either not installed or is improperly installed. To fix this, install the toner cartridge correctly.
What to do if Oki Copier says 'READY (FINISHER FULL)'?
If the Oki Copier displays 'READY (FINISHER FULL)', it means the receiving tray of the finisher is full of paper. Remove the paper from the receiving tray to resolve this.
What to do if there is a paper jam during printing with Oki Copier?
If a paper jam occurs during printing with your Oki Copier, open the cover indicated by the flashing light and check for and remove the jammed paper.
How to fix paper misfeed in Oki Copier?
If a paper misfeed occurs inside the Oki Copier, remove the misfed paper by following the instructions displayed on the touch panel.
What to do if Oki Copier displays 'READY (CHECK STAPLER)'?
If your Oki Copier shows 'READY (CHECK STAPLER)', a staple jam has occurred in the finisher's stapler. Remove the jammed staples to clear the error.
What to do if the Oki Copier says 'Check paper size setting on touch panel for tray N'?
This message on your Oki Copier indicates a mismatch between the paper size in tray N and the size registered for tray N in the equipment, causing a paper misfeed. Correctly register the paper size in the equipment. Simply removing the misfed paper will not prevent future misfeeds.
What to do if Oki Copier says 'Cannot print this paper size Select the other tray'?
If your Oki Copier displays 'Cannot print this paper size Select the other tray', it means the selected tray is not suitable for the paper size you are trying to print. Delete the failed print job, select the appropriate tray for the paper, and try printing again.
What to do if Oki Copier says 'Cannot print this paper type Set the other paper type'?
If your Oki Copier displays 'Cannot print this paper type Set the other paper type', it means the selected tray is not suitable for the paper type you are trying to print. Delete the failed print job, select the appropriate tray for the paper, and perform printing again.
General| Brand | Oki |
|---|---|
| Model | ES7170dn MFP |
| Category | All in One Printer |
| Language | English |
To Next Page
