Oki Microline 3320 - Power Requirements and Environmental Specifications; Impact and Reliability

2 – 31
(c) BOTTOM (Continuous sheet from bottom feeder) (option)
When the change lever is set in the BOTTOM position, the rotation of the platen
is transmitted to the drive gear of the bottom tractor feed unit through the idle gear
to feed the sheet which has been set in the bottom tractor feed.
At the same time, the switch lever turns on the bottom switch, to confirm to the control
board that you are in the continuous sheet mode.
Correlation in Mechanism
Mechanism
Lever
Position
Rear
Switch
Bottom
Switch
Idle
Gear
Change
Gear
Tractor
Gear
Sheet
Insertion
Manual/
automatic
CSF:

Operation SW 
or instruction
•


•
Operation 
SW 
or
instruction
•


•
Operation 
SW 
or
instruction
TOP
REAR
BOTTOM
OFF
ON
OFF
OFF
OFF
ON
Rotate
Rotate
Rotate
Stop
Rotate
Rotate
Stop
Rotate
Stop