Microline 8480FB User’s Guide
Loading Print Media • 23
6. Close the tractor covers and fine tune the position of the right
tractor until the holes in the paper are centered on the pins, then
push back the right tractor lock lever.
7. Lower the platform.
8. Position the continuous forms stack below the printer with no
more than about 1 inch (3 cm) offset (1).
Switching Between Normal and High
Impact Mode
Normal to High Impact Print Mode
Press MODE / HIGH IMPACT.
The LED beside HIGH IMPACT comes on and
H-IMPCT
appears at the end of the first line of the display.
To Next Page
Loading...
