Microline 8480FB User’s Guide
Explanation of Function Setting Menu Items • 50
•paper moves up.
Positive values stop the printing further up on the form:
•Paper End moves up
paper moves down
PE Pos. [Paper End Position]
This sets when the the printer will move to the next continuous
form, based on the distance between the center of the characters
on the last line of the form and the bottom of the form. Available
settings: 3.18 mm (1/8") or 6.35 mm (1/4") [the default].
Pitch
Choose the character width, in characters per inch (cpi): 10 [the
default], 12, 15, 17.1, or 20 cpi.
Power Save Time
Sets the time the printer waits before entering the Power Save
Mode when Power Saving is set to Enable [the default]: 5 min, 10
min [the default], 15 min, 30 min, or 60 min.
Power Saving
Sets whether or not the printer enters the energy-saving Power
Save Mode after the interval specified under Power Save Time. The
default is Enable.
Print Dir. Cmd.
The default is Valid: the printer will recognize a command for
unidirectional printing. Change to Invalid if you do not wish the
printer to recognize uni-directional printing commands.
Print Mode
Choose the print quality and speed: LQ Courier [the default], LQ
Roman, LQ Swiss, LQ Swiss Bold, LQ Orator, LQ Gothic, LQ
Prestige, or Utility.
Print Suppress
The default is No. If your system uses the DC1 and DC3 codes for
print suppress mode, change the setting to Yes.
To Next Page
Loading...
