Microline 8480FB User’s Guide
Explanation of Function Setting Menu Items • 49
Page Width
Choose the width of the continuous forms paper you are using:
8", 10.6", 13.2", or 13.6" [the default].
Paper End
Choose what happens when paper end is detected when you are
using manual feed from the platform: On-line [the default] or Off-
line.
Parallel I/F
Note Only Nibble Mode supports bi-directional.
Choose the printing used by the parallel interface: Uni-directional
or Bi-directional [the default].
Path Change
Choose whether or not the Tear Off feature (see page 60) is
engaged when you change to the continuous forms path. The
default is off (Not Tear Off). To set the printer to automatically
engage the Form Tear feature when it switches to continuous
forms printing, change the setting to Tear Off.
PE Adj. (Cut) [Paper End Adjust (Manual Feed)]
For fine tuning the location of the last line of printing (Paper End)
when using manual feed from the platform. Settable from -15 to
+15 in increments of 1/120 inch. The default is 0.
Negative values allow printing further down on the form:
• Paper End moves down
•paper moves up.
Positive values stop the printing further up on the form:
•Paper End moves up
•paper moves down
PE Adj. (Front) [Paper End Adjust (Front Feed)]
For fine tuning the location of the last line of printing (Paper End)
when using continuous forms (front feed). Settable from -15 to
+15 in increments of 1/120 inch. The default is 0.
Negative values allow printing further down on the form:
• Paper End moves down
To Next Page
Loading...
