Microline 8480FB User’s Guide
Explanation of Function Setting Menu Items • 51
Prop. Spacing
The default is No. Choose Yes to engage proportional spacing of
characters.
Quiet
The default is Invalid. Choose Valid to reduce printing noise.
Rcv. Buffer
Sets the amount of memory ( 0 or 128 Kbytes) devoted to holding
received data. The default is 128 Kbytes. Changing this to 0 will tie
up your computer while printing, but if you abort the print job, the
printer will stop much sooner.
Regist. Low
Adjusts the print registration for low-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. Normal
Adjusts the print registration for normal-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. High 1
Adjust the print registration for high-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. High 2
Adjust the print registration for draft mode printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Reset Inhibit
The default is No. Change this to Yes to prevent your software
from resetting your printer’s settings. The printer will ignore an
INITIAL command.
SI Pitch (10)
IBM emulation only.
Sets the pitch to be engaged when the printer control panel is set
for 10 cpi and the SI command is received. Choose 15 cpi or 17.1
cpi [the default].
To Next Page
Loading...
