Oki ML3410 - Menu Selections: Serial Interface Diagnostics

Diagnostic Test
No
, Yes Set to Yes to run the
serial interface
diagnostic test. To
restore to full
opera-tion, turn the
printer off, then hold
down the the PRINT
QUALITY and PITCH
buttons while you turn
on the printer. This
will put you into the
menu mode; you can
then change this
setting to No for
normal operation.
Busy Line
SSD-
, SSD+, DTR,
RTS
Baud Rate 19200 BPS,
9600
BPS
, 4800 BPS,
2400 BPS, 1200
BPS, 600 BPS, 300
BPS
DSR Signal
Valid
, Invalid
DTR Signal
Ready on Power Up
,
Ready on Select
Busy Time Busy Time
200 mS
,1
sec
ML3410 ( 96-02-07 )