Oki ML3410 - Menu Selections: Interface Parameters

Time Out Print
(Epson/IBM)
Valid
, Invalid When set to Valid,
con- tents of the
buffer will print when
no more data is
received for a certain
period of time.
Auto Select
No
,Yes
Sensor Disable
No
,Yes
Parallel I/F I-Prime
Buffer Print
, Line
End, Invalid
End, Invalid Buffer
Print = I-Prime makes
printer print con- tents
of buffer; Line End =
I-Prime makes printer
print to the end of the
current line; Invalid =
I-Prime signal is
ignored.
Pin 18
+5V
, 0V Determines whether
volt-age is supplied to
pin 18.
Auto Feed XT
(Epson/IBM)
Invalid
, Valid Epson emulation.
Some interface
cables are wired so
that the XT signal
always causes an
auto-matic line feed.
The In-valid setting
eliminates this. Use
the Valid setting if
your system uses the
XT signal for
automatic line feed.
Serial I/F Parity
None
, Odd,
Even Serial Data 7 or
8 Bits
8 Bits
,7 Bits
Protocol
Ready/Busy
, X-ON/
X-OFF
ML3410 ( 96-02-07 )