Oki ML3410 - Menu Selections: Operator Panel Function

Operator Panel
Function
Full Operation
,
Limited Operation
Changing this setting
to Limited Operation
deacti-vates the menu
mode and these
control panel
but-tons: TOP OF
FORM, MICRO
FEED UP/DOWN,
PRINT QUALITY, and
PITCH. This is used
in situations where
several people are
using the printer. To
restore to full
operation, turn the
printer off, then hold
down the the PRINT
QUALITY and PITCH
buttons while you turn
on the printer. This
will put you into the
menu mode; you can
then change this
setting to Full
Operation.
Reset Inhibit
No
, Yes Changing this to Yes
pre-vents a reset
signal from the
computer from
reset-ting the printer
to its de-faults.
Print Suppress
Effective
Yes
, No Determines whether
the DC3 code causes
the printer to ignore
data until a DC1 code
is received.
Auto LF
No
,Yes
Auto CR (IBM only)
No
,Yes
CSF Bin Select
Bin 1
, Bin 2 Only available when
the CSF 3002 is
installed. Determines
which bin is active.
SI Select Pitch (10
CPI) (IBM only)
17.1 CPI
15 CPI Sets the pitch of
con-densed mode
from 10 CPI using the
SI code.
SI Select Pitch (12
CPI) (IBM only)
20 CPI
12 CPI Sets the pitch of con-
densed mode from 12
CPI using the SI
code.
ML3410 ( 96-02-07 )