MENU MODE > 38
overridden by the software’s settings when the I-Prime signal
is sent.
Language Set, Default = ASCII
Replaces certain standard symbols with special characters used in
foreign languages.
Line Spacing, Default = 6 lpi
Change to 8 lines per inch (lpi) to get more lines on a page.
Operator Panel Function, Default = Full Operation
Change to Limited Operation to deactivate the
PRINT QUALITY
and
CHARACTER PITCH
buttons, so that these features can only be
controlled through your software. This prevents these from being
changed from the control panel when several people are using the
printer.
Page Length, Default = 11-2/3" or 1/2"
Selects the length of the paper you are using. This enables the printer
to keep track of the initial printing position (TOF) on each page.
Page Length Control, Default = by Actual Page Length
If you wish to use the Paper End sensor to detect the actual paper end,
use
Actual Page Length
setting. If you use “by Menu Setting”, the
printer will disregard the Paper End (PE) and use the page length as
set by the menu.
Page Width, Default = 13.6"
Wide carriage model only.
NOTE
This feature also prevents access to the Menu. To access the Menu in
these circumstances, turn the printer off, then hold down the
SEL
key
while turning ON the printer.
To Next Page
Loading...
Need help?
General
