MENU MODE > 34
EXPLANATION OF MENU ITEMS
These explanations are in alphabetical sequence to make it easier to
look them up. Some items only appear when optional accessories are
installed; others appear in several groups in the menu.
7 or 8 Bit Graphics, Default = 7
Change this setting to 8 if your system uses 8-bit graphics.
7 or 8 Bit Data Word, Default = 8
Change this setting to 7 if your system uses 7-bit data word lengths.
Auto CR, Default =No
IBM emulation only. If you want the printer to automatically add a
carriage return when a Line Feed is received at the end of a line,
change the setting to Yes.
Auto LF, Default = No
If your printout is consistently double spaced, select No; if it
overprints, select Yes.
Auto Feed XT, Default = Invalid
Epson emulation only. In the Epson emulation, the XT signal on pin 14
of the parallel interface can control automatic line feed. Some
interface cables are wired in such a way that automatic line feed is
always in effect: this item eliminates this potential problem. If your
system uses pin 14 of the parallel interface to control automatic line
feed, change the setting to Valid.
Auto Select, Default = No
Determines whether or not your printer will automatically be selected
after you load in paper. With the factory default engaged, the printer
will be deselected so that you can set the Top of Form. If you always
use the same Top of Form position, change the setting to Yes.
To Next Page
Loading...
Need help?
General
