List of the Device Setting Menu Items
-97-
Configuring at the Operator Panel
6
Network
Setting
WINS Server (Secondary) 0.0.0.0 Sets a name or an IP address for the
WINS server.
Display condition: TCP/IP protocol is
enabled and the IP version is not set to
IPv6.
Web Enable Sets whether to enable access from a
web browser.
Display condition: TCP/IP protocol is
enabled.
Telnet Disable Sets whether to enable access from the
Telnet.
Display condition: TCP/IP protocol is
enabled.
FTP Disable Sets whether to enable access from FTP.
Display condition: TCP/IP protocol is
enabled.
IPSec Disable This item is displayed and it can be dis-
abled only when IPSec is set to valid.
SNMP Enable Sets whether to enable access from
SNMP.
Display condition: Netware is enabled
and TCP/IP is enabled.
Network Scale Normal When [Normal] is set: the machine
works effectively even when connected to
a HUB that has a spanning tree feature.
However, printer start up time gets lon-
ger when computers are connected to
two or three small LANs.
When [
Small
] is set: computers can cover
from two or three small LANs to a largeLAN,
but it may not work effectively when it is con-
nected to a HUB with a spanning tree feature.
HUB Link Setting Auto
Negoti-
ate
Sets the hub linking method. Usually,
select [Auto Negotiate].
TCP ACK Type1 Sets a type of TCP Acknowledgment.
When Type1 is set, the printer replies to
every packet.
When Type2 is set, the printer replies to
plural packets in a mass.
When printing comes to take time by the
setting of the hub, choosing Type2 may
improve the matter.
Usually, setting Type1 hasn't any problem.
Network PS-Protocol (MB451/MB451w/MB471/
MB471w/MB491/MB491+/MB491+LP/ES4191
MFP/MPS4200mb/MPS4700mb Only)
RAW Sets a PS-protocol.
Item
Factory
Default
Description
To Next Page
Loading...
