78
11-5. Power Specifications
(1) Rated Input Voltage: 100-240V, 50-60Hz
(2) Rated Input Current: 1.1A
(3) Operating Voltage: DC24V±1０%
(4) Power Consumption: During standby:
3.0W or less/0.1A on average (Dual Interface)
4.5W or less/0.1A on average (LAN Interface)
During operation: About38W/1.5A on average
(at 24V, 25°C, print density setting 100%, paper
width 80mm, print duty 9%)
Note: Drawer Kick Drive Current: Max. 1A
However, do not operate two drawer kick at the
same time.
2
1
3
Power C
onnector Pin Assignment
Pin No. Signal Name
1
+24V
2 SG
3 N.C
Caution: Use the specified AC adapter for the power supply.
Caution: If our AC adapter is not used (power supply is supplied by the
user), problems such as bad print quality, electromagnetic
interference, or circuit noise may occur. In such cases, take
note of the following points:
· Use an AC adapter whose capacity corresponds to the printing
rate that will actually be used.
· Ensure in advance that there are no problems such as static
electricity, electromagnetic interference, circuit noise, etc.
To Next Page
Loading...