4742-E P-66
SECTION 2 DC POWER SUPPLY UNIT (MPS, MPR UNIT)
(3) The procedure for removing the plastic cover at the upper and lower terminal blocks is indicated
below.
• Plastic cover at the upper terminal block
After pushing in the lock lightly, tilt the cover 10 deg. to the front and the cover can be taken
out upward.
• Plastic cover at the lower terminal block
After pushing in the lock lightly, turn the cover 90 deg. then pull the cover to the front and the
cover can be removed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...