SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will be
muted and SCAN will appear on the display.
AM-FM:
Press this button to play the radio when a tape
is in the player. The tape will stop but remain in the
player.
TAPE-CD:
Press this button to change to the tape
function when the radio is on. A box will appear around
TP
on the display when the tape is active. Press AM-FM
to return to the radio while a tape is playing.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition or radio off. Cassettes may be loaded with the
radio off if this button is pressed first.
CLN:
This message may appear on the display. If it
does, your cassette tape player needs to be cleaned. It
will still play tapes, but you should clean
it
as soon as
possible to prevent damage to your tapes and pliyer. See
“Care of Your Cassette Tape Player” in the Index. After
you clean the player, press and hold EJECT for five
seconds to reset the CLN indicator. The radio will
display
---
to show the indicator was reset.
Playing a Compact Disc
If you have the optional trunk mounted
CD
changer, you
can play up to
12
discs continuously. Normal size discs
may be played using the trays supplied in the magazine.
The small discs
(8 cm) can be played only with specially
designed trays.
I
I
A
L
You must first load the magazine with discs before you
can play a compact disc. Each of the
12
trays holds one
disc. Press the button on the back of the magazine and
pull gently on one of the trays. Load
the
trays from
bottom to top, placing a disc on the tray label side down.
To Next Page
Loading...
Need help?
General
