While the tape is playing, use the VOL, FADE, BAL,
TREB and BASS controls just as you do for the radio.
The display will show TP with a box around
it
and an
arrow to show which side
of the tape is playing.
Your tape bias is set automatically. When a metal or
chrome tape is inserted,
HI-BIAS
appears on the
display.
If
you want to insert a tape when the ignition is
off, first press EJECT or RCL.
If
E
and a number appear on the radio display, the tape
won’t play because
of
an error.
0
E10:
The tape is tight and the player can’t turn the
tape hubs. Remove the tape. Hold the tape with the
open end down and try to turn the right hub
counterclockwise with a pencil. Turn the tape over
and repeat. If the hubs do not turn easily, your tape
may be damaged and should not be used in thecd
..
player. Try a new tape to make sure your player is
working properly.
0
Ell:
The tape is broken. Try a new tape.
If
any error occurs repeatedly or if an error can’t be
corrected, please contact your retailer.
If
your radio
displays an error number, write
it
down and provide
it
to
your retailer when reporting the problem.
REV (1):
Press this button to reverse the tape rapidly.
Press it again to return
to
playing speed. The radio will
play the last-selected station while the tape reverses.
You may select stations during REV operation by
using TUNE.
FWD
(2):
Press this button to advance quickly
to
another part
of
the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during FWD operation by using
TUNE.
PROG
(3):
Press this button to play the other side
of the tape.
NR
(4):
Press this button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
SEEK:
Press the up or down arrow to search for the next
or previous selection on the tape.
To
go
to the start of the
last selection played, press the down arrow again as
it
stops at the
start
of a selection. The radio will not play
while seeking. Your tape must have at least three seconds
of
silence between each selection for
SEEK
to work.
-
-3
To Next Page
Loading...
