SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds
of
silence between each
selection for SEEK to work.
SCAN:
Press this button to listen to each selection for a
few
seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will be
muted, SCAN will appear on the display and the tape
direction arrow will blink while scanning.
TONE:
Press this button to select a TONE while
playing a cassette. The tone will be automatically set
whenever you play a cassette tape.
AM-FM:
Press this button to play the radio when a tape
is in the player. The tape will stop but remain in the
player.
TAPE-CD:
Press this button if you have a disc loaded
in the changer and the radio is playing,
to
play a
compact disc. Press
AM-FM
to return to the radio when
a compact disc is playing. Press TAPE-CD to switch
between the tape and compact disc
if
both are loaded.
The inactive tape or CD will remain safely inside the
radio for future listening.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition or radio off. Cassettes may be loaded with the
radio and ignition
off
if this button is pressed first.
CLN:
This message may appear on the display. If it
does, your cassette tape player needs to be cleaned. It
will still play tapes, but you should clean it as soon as
possible to prevent damage to your tapes and player.
See “Care
of
Your Cassette Tape Player” in the Index.
After you clean the player, press and hold EJECT for
five seconds to reset the CLN indicator. The radio will
display
---
to show the indicator was reset.
rlaylng
a
4
The CD player will play either normal-size discs or the
smaller
8
cm discs without an adapter.
With the ignition on, insert a disc partway into the slot,
label side
up.
The player will pull
it
in and the disc
should begin playing.
Note that when the disc is inserted, CD will be
displayed. When the disc is playing, a box will appear
around
CD
on
the
display.
If
you select a tone setting for
your CD,
it
will be activated each time you play a CD.
To Next Page
Loading...
