4.
Lift the tabs to remove the bulb from the assembly.
5.
Replace the bulb.
6.
Push the bulb assembly in and turn it clockwise to
install the bulb assembly into the headlamp
assembly.
7.
Then reconnect the wiring harness to the lamp
assem bly.
8. Slide the lamp assembly back into place by lining
up the track on the bottom
of
the assembly with
the guide on the vehicle.
9.
Then connect the outboard snap mounting pin.
IO.
Secure the lamp assembly with the two bolts.
5-56
To Next Page
Loading...
