Oleo-Mac GS200E - Maintenance Chart

32
I
GB
F
D
E
SK
P
GR
TR
CZ
RUS
UK
PL
9. STORAGE
If the machine is to be stored for long periods:
- Make see that the electrical plug is
disconnected from the mains.
- Follow all the maintenance regulations
described above.
- Completely empty the tank of chain
lubricant and close the cap
- Run the machine empty to completely
empty also the delivery pipe and the oil
pump.
- Clean the saw thoroughly.
- Put the blade-cover on. Store the saw in a
dry place, preferably off the ground, and
away from heat sources.
MAINTENANCE CHART
Please note that the following maintenance intervals apply for
normal operating conditions only. If your daily work requires
longer than normal or harsh cutting conditions are present the
suggested intervals should be shortened accordingly.
Before Each Use
After Each
Refueling Stop
Weehly
If Damaged or
Faulty
As Required
Complete Machine Inspect (Leaks, Cracks, and Wear)
XX
Controls (on/o switch,
safety button)
Check Operation
XX
Chain Brake Check Operation
XX
Check by Dealer
X
Oil Tank Inspect (Leaks, Cracks, and Wear)
XX
Chain Lubrication Check operation
XX
Saw Chain Inspect (Damage, Sharpness, and
Wear)
XX
Check Tension
XX
Sharpen (Check Gauge Depth)
X
Guide Bar Inspect (Damage, and Wear)
XX
Clean Bar groove and Oil Passages
X
Rotate, Lubricate Sprocket Nose and
Deburr
X
Replace
X
Rim Sprocket Inspect (Damage, and Wear)
X
Replace with
every new
chain
Chain Catcher Inspect (Damage, and Wear)
XX
Replace
X
All Accessible Screws
and Nuts
Inspect - Retighten
X
Motor crankcase
louvers
Clean
X
Power cable Inspect (Damage, and Wear)
X