Olimpia splendid OS-CEBTH60EI - Setting User Menu Parameters

50
ENGLISH
3
To set the parameters see the table below that summarises the parameters.
Example:
Press ey4
, to view USr on the display
Press ey6
, to view the rst parameter hrS (clock hour setting)
Press ey6
, to view the parameter value (e.g.: 10)
Press ey6
for three seconds, the parameter value ashes on the display
Press ey1
/ey2 to increase or reduce the parameter value displayed
Press ey6
, to conrm the set value, the display stops ashing
Press ey4
, to exit and view the parameter
Press ey1
or ey2 to change parameter and proceed as above to change other parameters
Press ey1
and ey2 simultaneously to quit the user menu
Parameter DISPLAY
MNEMONIC
MENU Range of
adMustment
Factory
setting
COMMENTS
SSTEM CLOC:
HOUR SETTING
hS User 0-23 0
SSTEM CLOC:
MINUTE SETTING
in User 0-59 0
TIMER ACTIVATION/
DEACTIVATION
0  timer deactivated
1  timer activated
ti User 0-1 0
SSTEM START TIME
StA User 00.0 – 23.5 0.00
Decimals  tens of minutes,
e.g.: 0.110 minutes, 0.550
minutes
SSTEM SHUTDOWN
TIME Sto User 00.0 – 23.5 0.00
Decimals  tens of minutes,
e.g.: 0.110 minutes, 0.550
minutes
NIGHT-TIME MODE
ACTIVATION/
DEACTIVATION
0  night-time mode
deactivated
1  night-time mode
activated
ncL User 0,1 0
The yield and the maximum
noise level are reduced
NIGHT-TIME MODE
SWITCH-ON TIME nSt User 00.0 – 23.5 0.00
Decimals  tens of minutes,
e.g.: 0.110 minutes, 0.550
minutes
NIGHT-TIME MODE
SHUTDOWN TIME nSP User 00.0 – 23.5 0.00
Decimals  tens of minutes,
e.g.: 0.110 minutes, 0.550
minutes
Inlet water temperature
t1
Temperature/
Set
Outlet water
temperature
t2
Temperature/
Set
Domestic water tank
sensor temperature
t3
Temperature/
Set
Outside air sensor
temperature
t4
Temperature/
Set
Compressor operating
hours CHC
Temperature/
Set
COOLING SET-POINT
1
cS1
Temperature/
Set
User
Luc0: 7°C
- 25°C
Luc1: 4°C
- 20°C
Luc0: 20°C
Luc1: 15°C
Factory settings for radiant
oors
COOLING SET-POINT
2 (Eco Mode)
cS2
Temperature/
Set
User
Luc0: 7°C
- 25°C
Luc1: 4°C
- 20°C
Luc0: 23°C
Luc1: 18°C
Factory settings for radiant
oors
HEATING SET-POINT
1
HS1
Temperature/
Set
User
Luc0: 20°C
- 55°C
Luc1: 20°C
- 60°C
Luc0: 30°C
Luc1: 35°C
Factory settings for radiant
oors