23.3.2005 Rev. 1.0
Installation
16
5.3 Possible environmental interference
If the appliance is installed with its sides next to flammable walls (made of wood or sim-
ilar materials) or to heat-sensitive walls (made of plasterboard or similar materials), suit-
able protective measures should be taken to keep such walls undamaged. Either apply a
coating over the wall to insulate it from radiative heat or keep a minimum clearance of
100 mm (4") from the sides and back of the appliance.
5.4 Storage
If the appliance is stored in a warehouse where room temperature is below 0°C (32°F), it
should be warmed up to at least +10°C (50°F) before switching it on.
5.5 Unpacking the appliance
Prior to installation, remove all packaging materials from the deep fat fryer. Some parts
are wrapped in adhesive film, which should be thoroughly removed. Remove any glue
traces left on the surfaces of the appliance using a suitable non-flammable solvent. Abso-
lutely avoid using abrasive substances.
5.6 Disposing of packaging materials
All packaging materials should be disposed of in compliance with the local regulations in
force where the appliance is installed. Packaging materials should be separated according
to their types and delivered to specific collection sites. Please abide by environmental pro-
tection regulations.
5.7 Positioning
Level the appliance using a bubble level. Small adjustments can be done with the help of
the adjustable feet.
To Next Page
Loading...