732-R FRONT LOAD SLICER
0732S20023 5-2
Trouble Shooting (Continued)
The Slicer Will Not Start (Motor Is Humming)
CAUTION
DO NOT ALLOW THE MOTOR TO HUM WITHOUT STARTING.
OVERHEATING CAN PERMANENTLY DAMAGE THE MOTOR.
NOTE
A SPECIAL NON-VENTILATED MOTOR MUST BE USED WITH THIS SLICER.
• The drive system is binding. (Have a qualified service agent check for defective
bearings or other restrictions to free movement.)
• There is mechanical interference between other parts of the slicer. (Have a qualified
service agent evaluate the machine for adjustment or replacement of defective
parts.)
• The motor has failed. (Have it checked by a qualified electrician.)
The Slicer Stops Before Slicing is Complete
• The upper limit switch is not adjusted properly. (Have a qualified service agent
adjust the switch.)
The Slicer Does Not Automatically Stop Upon Completion of Slicing
• The upper limit switch is not adjusted properly. (Have a qualified service agent
adjust the switch.)
• The upper limit switch is defective. (Have a qualified electrician check and replace
the switch if required.)
• A bread crust or other foreign object is preventing the cradle from returning to the top
of its travel.
Continued
To Next Page
