To Next Page

To Previous Page

690-NC2

0690S20043 4-2

Idle Mode

From Idle mode you can:

• Run an automatic program.

• Run a manual program.

• Adjust the temperature.

• add steam.

• open and close the vent.

• change the fan setting.

Running an Automatic Program

1. From Idle mode

enter the program number (01 - 40) using the keypad

2. Wait 3 seconds or press the start key to begin preheat stage.

3. Wait for oven to reach set temperature. The display will show lo or hi and the menu

number. When the set point is reached the buzzer will sound and the display will

show ready

4. Put product into the oven.

5. Close door, bake begins.

6. Pre-Alarm #1

will sound if programmed, press

CANCEL

START

to cancel the alarm.

For more details see the Pre-Alarm section.

7. Alarm will sound when bake is finished and display will show

. and the

program number

Open the door to end the program, this will hold the current bake temperature, add time

if required by pressing the up button. OR

Press cancel

CANCEL

START

to end the bake and return the holding temperature to 250 °F.

Oliver NC User Manual

Questions and Answers: