690-NC2
0690S20044 5-1
PROGRAMMING
The following are instructions for editing and creating a menu program.
1. Enter the Program Mode by pressing the up and down keys
simultaneously for 5 seconds.
2. Display shows
for MENU.
3. Key in the menu number you want to program (01-40), or use the up and down keys
to scroll.
Programs 01-20 can hold two stages.
Programs 21-40 hold one stage
4. Press the ‘next’ key
to edit/program the first parameter of the menu.
5. Display will show
for Pre-Heat. Use the up and down keys or the keypad to
enter the preheat temperature. Press the next key
to advance.
6. Display will show
for Temperature Compensation. Use the up and down
keys
to adjust temperature Compensation to on or off. Press the next
key
to advance.
7. Display will show
for steam. Use the up and down keys to adjust the steam
time between 0-30, C2, C3, and C4. C2 produces two cycles of 15 second steam.
C3 produces three cycles etc. Press ‘next’ key to advance.
8. Display will show
for stage 1 time. Use up and down keys or keypad to
enter the time in minutes and seconds. Press ‘next’ key to advance.
Example: Enter 1200 for twelve minutes and zero seconds.
9. Display will show
for stage 1 Temperature. Use up and down keys or
keypad to enter the Temperature between 250°F and 500°F. Press the ‘next’ key to
advance.
10. Display will show
for stage 1 fan. Use up and down keys to scroll between
Hi and Lo fans. Press ‘next’ key to advance.
To Next Page
Loading...
Need help?
General