690-NC2
0690S20046 6-4
Steam Is Leaking From the Door
It is normal for some steam to escape from the door during the steaming operation,
however, if excessive amounts escape you should check the following.
• The door seal may be damaged.
• The door may not be latching properly.
The Door Will Not Close
• Slamming the door too hard can cause it to bounce off of the seals, not allowing the
door time enough to latch properly.
• Sometimes after replacement of the door seals the strike may need to be re-
shimmed to generate the proper seal. Remember only a single shim should be
used, order shim kit number 690-0148K when replacing seals.
• Check for a worn or broken latch or strike.
• The Latch mounted to the door may be too far away from the strike. It may be
adjusted left to right.
One or both of The Blower Fans Will Not Run
• The oven liner may be rubbing on the fan preventing its rotation.
• A motor fuse may need to be replaced.
• The door switch may not be working.
• The fault/high limit lamp is on, see the trouble shooting suggestions for this area
above.
• The high limit switch has failed.
• A blower fan motor may have failed.
The Blower Fans Run Continuously
Other than when the oven is in “Cool Down” mode the blower fans should not run when
the door is open. Things which may make this happen are:
• A failure of the door switch.
• A blower fan motor contactor failure.
To Next Page
Loading...
Need help?
General